Knowledgebase: Revit
Revit - Property Lines
Posted by Kent Watson, Last modified by Kent Watson on 09 February 2015 06:02 PM

Tip Title:      Revit Property Boundary

Product:      Revit

Author:        Kent Watson – Technical Consultant

 

Issue:

When creating property lines by entering distances and bearings into a table you are required to enter bearings east or west of north and south.

 

Solution:

From the Massing & Site tab of the ribbon find the Model Site panel and at the bottom right of that panel click the down arrow

 

Change the Angle Display from “Degrees from N/S” to “Degrees” and click OK

 

Now in the Property Lines dialogue box you will be using Azimuth bearings and distances

 

 

(4 vote(s))
Helpful
Not helpful

Comments (0)