Knowledgebase:
Windows - Increase system memory for faster system response
Posted by Kent Watson on 13 October 2014 04:12 PM

Tip Title:      Increase system memory for faster system response

Product:      Windows Systems: 7, 8

Author:        Florian Neumayr – Application Specialist

 

Issue:

File operations on Windows NT based systems make use of a limited pool of kernel buffers. This may slow down or even bring to a halt file operations on Windows if the buffers are filled up so that they, for the time being, cannot accept new file operations.

The memory usage of the buffers can be increased from an elevated command line prompt or the Windows Registry.

Microsoft TechNet offers the following description of the memoryusage value:

Configures the internal cache levels of NTFS paged pool and NTFS non-paged pool memory. Set to 1 or 2. When set to 1 (the default), NTFS uses the default amount of paged pool memory. When set to 2, NTFS increases the size of its lookaside lists and memory thresholds. A lookaside list is a pool of fixed-size kernel memory buffers that the kernel and device drivers create as private memory caches for file system operations, such as reading a file.

Solution:

Increasing Memory Usage via the command line:

An elevated command prompt is required for this operation. Click start, then All Programs, locate Accessories, right-click Command Prompt in the listing and select to Run As Administrator.

elevated command prompt

elevated command prompt

Issue the following command to increase the limit of paged pool memory:

fsutil behavior set memoryusage 2

fsutil memoryusage

fsutil memoryusage

Windows will return the new value in the same command prompt.

Windows users who would like to restore the old setting can issue the following command instead:

fsutil behavior set memoryusage 1

Increasing Memory Usage via the Windows Registry:

Open the Windows Registry Editor by either clicking on Start again and typing in regedit in the run box or by pressing Windows-R and typing in regedit in the opening run dialog window.

Navigate to the following Registry key:

HKEY_LOCAL_MACHINE\SYSTEM \CurrentControlSet\Control\FileSystem

Locate the entry NtfsMemoryUsage in the right window. Three possible values can be set:

  • Not Set: 0
  • Default: 1
  • Increased: 2

registry memory usage

registry memory usage

A restart of the computer system is required before the change will take effect, regardless whether it has been applied to the Registry or the command line.

It is probably a good idea to test the system in real-life situations after the restart to see if the speed gains are noticeable and verify that it continues to run stable.

(4 vote(s))
Helpful
Not helpful

Comments (0)